Wash in warm water and mild
soap. Do not put your cap in the dryer.
Wring out the excess water,
insert your fists into the cap, stretch out any wrinkles.
Place cap on your knee with
the bill pointing toward you. Using your palms, 'iron' the bill on your thigh,
setting the shape of the bill.
Crease the seam on top of the
cap, crease a few angles, and allow the hat to dry. Cotton has the ability
to retain its shape.
Shaping
your Road Rag In between washes:
Get it wet and play with it!
Then wring out the excess water
Smooth out any wrinkles with your hands
Place the hat on your bent knee with the bill
of the hat facing you on your thigh. Shape the bill with your hands
Put the hat on, adjust shaping,
and ride it like you stole it!
Making a Pouch:
There are four belt loops
on your hat Fold the hat so the 2 right loops come together by folding
the material in towards the center of the hat
While still holding the
right loops take the hook at one end of the hat strap and hook the two
right loops together
Repet this step for the
left side and use the hook at the other end of the strap
Shape your pouch by pushing
your fist into the bottom of the newly formed pouch while pulling up on
the strap to center the bag
Fold the bill over, slip
the rear button through the slot in the bill.
Making an all purpose carrier:
For single or double can carriers see the instructions
above for making a pouch
For a six pack carrier - take off your hat
Lay your hat on a table with the top of the hat on
the table and with the bill facing away from you
On the back off the hat on either side of the velcro
adjustment tabs are two belt loops - thread the strap through each loop and
hook it to the fron loop
Grab the strap between the front and rear loops and
pull it up
